kraven update file name shortened with a "~"

[itopia]

Updating my Phillips with the Kraven update sent the file to Tivo but step 4 went wrong I get "upgrade.tar.gz: No such file or directory". Typed in ls -l / and I can see the file there but the name has been shortened to "upgrad~1.gz"

For step 4 I tried typing upgrad~1.gz in as the file name and it seemed to work I got bash so I went onto step 5 and typed
bash-2.02# cpio -i -H tar -d -F upgrade.tar and then got the following error cpio: upgrade.tar: No such file or directory

Now when I type ls -l / the file name has further shortened to upgrad~1 with no extension. I've read and I've searched and haven't found anything on the names automatically changing. Please advise.

Thanks

[BubbleLamp]

Your file name got shortened to 8.3 notation because you were using a FAT16 file system. No biggie. Just rename the upgrad~1 back to upgrade.tar

mv upgrad~1 upgrade.tar


and then run the cpio command on it.

[itopia]

I changed the file as you suggested and it worked. I then went to Step 6 and the tivo rebooted - when it came back up bash was gone. I rechecked the settings for Kraven part 2
Kraven’s Upgrade HyperTerminal settings, part duex
115200
N
8
1
Software & Hardware flow control off.

Still no bash. Is the Fat 16 messing up the steps again?

[BubbleLamp]

No, FAT16 has nothing to do with it. Re-check the baud rate, or try another term program.

[itopia]

Thanks again - advice on another program was perfect - up and running as far as I can tell. On that note is there a software adjustment number to know that 25Xtreme has been successfully updated with Kravens edition?

[BubbleLamp]

No, the update does not affect the Tivo's SW version number.