nazareth
10-30-2003, 05:18 AM
Hi,
I've followed the instructions located in various locations, and I think I've done most correctly. I've got an 80GB drive installed in my HDVR2, and have mastered the monte, and gotten a serial bash shell. The problem that I have is that I cannot get the network portion running, and I'm wondering if I'm missing something simple.
I've got 2 usb ethernet adapters, a 3com 3c460B and a Dlink DSB650Tx. Both seem to exhibit the same problem. Both of these are pegasus based adapters, so I load the usbcore, usb-ohci, and pegasus modules. Shortly after I load the pegasus module, the link lights on my adapter lights up, but I start getting periodic "unaligned access to <various address> in kernel mode at 0xc013610c" error message. I then set up the ip address, and run the "tnlited 23 /bin/bash -login&".
Some of the guides say you might get a few, but I cannot seem to get a telnet session to connect to the tnlighted daemon. If I watch the RxPkt count over the time the telnet is trying to connect, I do see the rx pkt count increment, but for each rx pkt, I seem to get on Unaligned Access error message.
Anyone have any ideas what might be causing this?
Thanks,
Sean
Edited: On the recommendation of NutKase, I posted follow-up info only to the "The HDVR2/DSR7000 Quick-Start How-To: From BASH to EXTRACTION" thread. I managed to solve the problem by using alternate drivers. See my update post for more info.
I've followed the instructions located in various locations, and I think I've done most correctly. I've got an 80GB drive installed in my HDVR2, and have mastered the monte, and gotten a serial bash shell. The problem that I have is that I cannot get the network portion running, and I'm wondering if I'm missing something simple.
I've got 2 usb ethernet adapters, a 3com 3c460B and a Dlink DSB650Tx. Both seem to exhibit the same problem. Both of these are pegasus based adapters, so I load the usbcore, usb-ohci, and pegasus modules. Shortly after I load the pegasus module, the link lights on my adapter lights up, but I start getting periodic "unaligned access to <various address> in kernel mode at 0xc013610c" error message. I then set up the ip address, and run the "tnlited 23 /bin/bash -login&".
Some of the guides say you might get a few, but I cannot seem to get a telnet session to connect to the tnlighted daemon. If I watch the RxPkt count over the time the telnet is trying to connect, I do see the rx pkt count increment, but for each rx pkt, I seem to get on Unaligned Access error message.
Anyone have any ideas what might be causing this?
Thanks,
Sean
Edited: On the recommendation of NutKase, I posted follow-up info only to the "The HDVR2/DSR7000 Quick-Start How-To: From BASH to EXTRACTION" thread. I managed to solve the problem by using alternate drivers. See my update post for more info.