PDA

View Full Version : No power light DSR6000



Willager
11-29-2003, 09:14 AM
Have a DSR6000 that a friend brought over to upgrade. When I first plugged it in the power light came on and the "powering up-please wait" came on, after about 5 seconds the power light started flickering on and off and the "powering up" flashed on and off in time. Then the light went out as did the screen. The fan still runs. I read that the "powering up" screen would come on even with a bad hard drive, so I'm thinking perhaps the power supply. Does anyone have a pin out with volatges for the power supply so I know what I should have?

Thanks

GREEK
11-29-2003, 07:05 PM
just pop off the ribbon cable (says parlex on it) from the supply to the board and flip it end for end and reseat it.

cali
11-29-2003, 08:22 PM
Originally posted by GREEK
just pop off the ribbon cable (says parlex on it) from the supply to the board and flip it end for end and reseat it.

And if that doesnt work, get a volt Meter and slighty adjust the "yellow" pot on the power supply to bring up the supply voltage a bit