slorenzen
08-11-2005, 10:04 PM
I have a different ip scheme and had to change my tivo ip and dreaded having to take out the hard drive. I exported out the rc file by ftp and opened it in crimson editor. However, i went through the bash prompts copying and pasting the edited lines to the command prompt. Here is what i copy and pasted:
ifconfig eth0 172.16.13.240 broadcast 172.16.13.255 netmask 255.255.255.128
route add default gw 172.16.13.250 netmask 0.0.0.0 metric 1
By linksys router is 172.16.13.250 and i assigned my tivo .240. After reboot i could not ping or get the tivo to connect to the linksys router. Am i really screwed here? DO i have to take out the hard drive to fix this? If so, what do i do with the hard drive, boot to the sleeper cd or what? Or can i hook my laptop to the network card on my tivo and with a crossover cable and ip settings on my laptop on the same subnet telnet into the tivo? Help me please if you can!! Thanks
ifconfig eth0 172.16.13.240 broadcast 172.16.13.255 netmask 255.255.255.128
route add default gw 172.16.13.250 netmask 0.0.0.0 metric 1
By linksys router is 172.16.13.250 and i assigned my tivo .240. After reboot i could not ping or get the tivo to connect to the linksys router. Am i really screwed here? DO i have to take out the hard drive to fix this? If so, what do i do with the hard drive, boot to the sleeper cd or what? Or can i hook my laptop to the network card on my tivo and with a crossover cable and ip settings on my laptop on the same subnet telnet into the tivo? Help me please if you can!! Thanks