atl001
03-08-2006, 08:31 PM
Hi Folks,
I have recently built a couple of refurb'd Weaknees DSR7000's to replace my old ultimate TV's. I used the zipper to enable MRV and HMO. All is good and I'm having fun.
The two DSR7000's and my HR10-250 are in the main room. I have a couple of multi channel RF modulators that pipe the signal from these, a VCR and a DVD player around the house on RG6 for the other televisions to watch. I use an IR relay system to allow control of the central equipment from the other rooms.
I was thinking it might be nice if I could replace this system with boxes at the remote locations that did nothing but use the MRV protocol to access the shows recorded on the central Tivos. I would want to use cat5 or maybe wireless to do this. Can this be done cheaply? I have no desire to add 5.99 mirroring fees for each remote television, not do I want to pull additional satellite leads to each location.
Could I use another DSR7000 with no dish attached and no access card in each remote location to do this? Would this be considered stealing? The DSR7000s have no contract required, and I would not be using guide data.
Thanks,
Drew
I have recently built a couple of refurb'd Weaknees DSR7000's to replace my old ultimate TV's. I used the zipper to enable MRV and HMO. All is good and I'm having fun.
The two DSR7000's and my HR10-250 are in the main room. I have a couple of multi channel RF modulators that pipe the signal from these, a VCR and a DVD player around the house on RG6 for the other televisions to watch. I use an IR relay system to allow control of the central equipment from the other rooms.
I was thinking it might be nice if I could replace this system with boxes at the remote locations that did nothing but use the MRV protocol to access the shows recorded on the central Tivos. I would want to use cat5 or maybe wireless to do this. Can this be done cheaply? I have no desire to add 5.99 mirroring fees for each remote television, not do I want to pull additional satellite leads to each location.
Could I use another DSR7000 with no dish attached and no access card in each remote location to do this? Would this be considered stealing? The DSR7000s have no contract required, and I would not be using guide data.
Thanks,
Drew