PDA

View Full Version : What can explain "Searching for Signal" with good Signal Strength?

rfc
10-21-2006, 07:50 AM
Hr10-250/Zinwell/5lnb dish plus 72.5/running 3.1.5f.

System was working fine briefly. Now, I can test signal strength and pull up 90's on 101, 110, 119, but auto config fails to find any satellites and (of course) I end up with "searching for signal on 1 and 2).

Any ideas?
lgkahn
10-21-2006, 09:35 AM
go through guided setup again and make sure you have the right kind of dish selected.. setting the wrong one can cause this on certain channels
rfc
10-21-2006, 03:46 PM
go through guided setup again and make sure you have the right kind of dish selected.. setting the wrong one can cause this on certain channels

3 lnb/2 inputs.