Hi8
10-11-2007, 12:27 PM
I've tried searching for this problem but came up EMT.
I've got a HR10-250 with a drive failing, and went to swap it out with one that I thought was all built ready to go and tested way back when ... months ago.
It boots fine, until it gets to the satellite screen, it just sits there at 0%
if I wait long enough it errors to the try again screen, or just go to Now Playing screen if I want to watch a pre-recorded show.
I first thought my cables were the problem as I just disconnected and reconnected them, but they seemed fine. Rebooted and the same thing happened.
Put my old drive back in and everything was back to normal.
I'm rebuilding the drive now, I just wanted to know if anyone has seen this before and might know what has happened. ??
I've got a HR10-250 with a drive failing, and went to swap it out with one that I thought was all built ready to go and tested way back when ... months ago.
It boots fine, until it gets to the satellite screen, it just sits there at 0%
if I wait long enough it errors to the try again screen, or just go to Now Playing screen if I want to watch a pre-recorded show.
I first thought my cables were the problem as I just disconnected and reconnected them, but they seemed fine. Rebooted and the same thing happened.
Put my old drive back in and everything was back to normal.
I'm rebuilding the drive now, I just wanted to know if anyone has seen this before and might know what has happened. ??