LoCoZx10R
08-06-2008, 07:28 PM
I am new to this site and have a few questions about this upgrade. How big of an internal drive will I be able to use? Is there a certain brand I need and will the DVR recognize the extra space of the new hard drive? I have never upgraded a DVR before and is there anything else I need to look at before doing the upgrade? Thanks in advance!
If you have an HR21-700, removing the hard drive has the following steps once you have the cover off.
1. Find the ribbon cable that connects the front panel to the mainboard. On the mainboad end, there is a plastic pull-tab on the connector. Gently pull on it to disconnect the cable.
2. Disconnect the SATA power and data cables from the old drive.
3. Unlatch the tabs holding the front panel onto the chassis and remove the front panel.
4. There is an L-shaped metal plate attached to one edge of the hard drive and the mainboard. Using a #2 Philips screwdriver, remove the screw attaching the plate to the mainboard. Leave the screws attached to the drive for now.
5. From the front of the unit, remove the two Philips screws securing the drive to the front of the chassis.
6. Lift out the old hard drive. Remove the remaining screws on the L-shaped plate
Reverse process to install new drive. Don't forget to reinsert the front panel ribbon cable.
If you have an HR21-700, removing the hard drive has the following steps once you have the cover off.
1. Find the ribbon cable that connects the front panel to the mainboard. On the mainboad end, there is a plastic pull-tab on the connector. Gently pull on it to disconnect the cable.
2. Disconnect the SATA power and data cables from the old drive.
3. Unlatch the tabs holding the front panel onto the chassis and remove the front panel.
4. There is an L-shaped metal plate attached to one edge of the hard drive and the mainboard. Using a #2 Philips screwdriver, remove the screw attaching the plate to the mainboard. Leave the screws attached to the drive for now.
5. From the front of the unit, remove the two Philips screws securing the drive to the front of the chassis.
6. Lift out the old hard drive. Remove the remaining screws on the L-shaped plate
Reverse process to install new drive. Don't forget to reinsert the front panel ribbon cable.