Search:

Hey SR712 :)

Where you been hiding? Been looking somewhere for you. ;)

Same problem here. Just started today. How do you doi the soft reboot if the TiVo wont power up?

Thanks for the reply. You've been very helpful!

Hi all,

I have a Hughes GXCEBOT series 1 DirectTiVo and the remote will only work from about 6 inches away. However it works fine when controlling the TV. Batteries are good. Is the the...

Thanks guys :)

This morning my Hughes DTiVo rebooted and is stuck in the powering up "almost there a few more seconds" mode. Anyone know whats wrong with it. Is been up and running fine for about a year now with...

What if you are putting a virgin 120GB drive as master and the original DTiVo 40GB drive (Not-xtreme'd) as slave. Can you use this upgrade?

Thanks!

Thanks

Well, I used the 200MB Sony T-60 file and it didn't ask me if the drive was over 30GB. All it asked after it was done running is if I wanted to run TivoMad. There were then a series of questions...

Yep, this is the road I was going down. Running a PIII550, 256MB RAM. I will give it a try. Thanks!

Thanks for the reply. I did it twice already. I was thinking of trying a different config such as cdrom as primary master and tivo a as secondary master to avoid any conflicts. I also read the the...

Thanks for the reply. I'm not refering to actual recording but the variable capacity estimate reported on the status screen. Shouldn't it report 35 hours on the status screen? I also have a Hughes...

I used 25xtreme on a 40 gig maxtor from a Sony T-60 this past weekend and I only get 28hrs of recording time. I did answer yes to the TiVoMad question. Any thoughts on why I didn't get 35 hours?
...

I got it.

Seems that this line:
mount: blockdevce /dev/hdb is write protected
mounting read only

is correct since it is referencing my CD-RW drive which is set up as Primary Slave (hdb). ...

When I try to run 25xtreme on a SAT-T60 I get the following message

mount: blockdevce /dev/hdb is write protected
mounting read only
sh: /cdrom/live/bin/25xtreme: Input/Outpit error

my setup...