Fast Forwarding with the HR20-700
Ok, I have a question. I just got a new HR20-700, downloaded the new updates, and started muddling through getting used to a new OS. I am trying to get the remote to sort of behave the same as my HR10-250.
When you Fast Forward the HR10-250 and then press play, it jumps back a few seconds. My HR20-700 doesn't. Is there any way to get the HR20-700 to exhibit the same behavior?
Not at this time -- that's one of the Tivo patents.
Christopher D. Heer
Originally Posted by Oscar Wilde
For now hit skip back once after you FF..
I figured as much... That's going to take some getting used to.
I experienced my first "lockup" this morning. I have all the latest downloads, but for some reason, I didn't have a picture. When I changed the channel the info would display on the screen but not the picture. I ended up pulling the power cord and rebooting the unit to get my picture back. Anyone else experiencing similar behavior?
After a software update you should reset the HR20 so it
Originally Posted by HisKid
boots up clean!
Any way to skip ahead to the next 'tick' ie 15 minutes or so. Like my old HR10-250 did?
On a 2 hour movie, it takes a LONG time to fast forward at (#4) to get to near the end of the movie. UGGH.
airf00, you hold down the FF button for at least 3 seconds then hit it again.
Thanks, I later found a post on hints and tips. Thanks
Originally Posted by beljah