1. Post in the correct forum (this is for non-TiVo DVRs like the HR20).
2. Attach the kernel log to the new post.
PlainBill
My HR10-250 that I hacked this past spring started freezing and rebooting itself frequently a couple of days ago. I'm not sure where to start or what to check to get this figured out. Can anyone offer any advice as to where I should start looking?
The symptoms are that it will reboot itself and work ok for a while (less that an hour) then start freezing and eventually reboot itself. When it comes up it has a message saying "The recorder was not able to find infomormation for all channels" the menu then has "Try again to aquire information".
I have tried to hook up the serial cable to get a boot log, but that does not work either. I am able to access it via network until it starts acting up.
Any ideas??
Thanks,
David
1. Post in the correct forum (this is for non-TiVo DVRs like the HR20).
2. Attach the kernel log to the new post.
PlainBill
There's a difference between needing help, and just being plain ole' lazy.
"You cannot teach a man anything. You can only help him find it for himself." Galileo Galilei (1564-1642)
HR20-700 with 2 TB, HR22-100, HR22-100, HR22-100, HR23-100 all running 0x5cd and networked.