Results 1 to 2 of 2

Thread: Dual Tuner on Hughes SD-DVR40

  1. #1
    Join Date
    Feb 2008
    Posts
    7

    Dual Tuner on Hughes SD-DVR40

    I recently purchased a used Hughes SD-DVR40 and hacked it to enable the usb ports so it could be connected to my home network. After connecting the unit to my satellite I noticed that the second tuner is not working. To verify that I had a good signal coming from the satellite I swapped the cables with no avail, the problem did not follow the cable.

    My question is, Is there a setting that has to be turned on to enable the second tuner or does it automatically detect the signal? My next option is to install the original drive and see if this corrects the problem.

    I am running software version 6.2a

    Any help would be greatly appriciated

  2. #2
    Join Date
    Feb 2008
    Posts
    7
    After further searching, I found the following post that was very helpful. Hope this helps someone. Ended up I simply needed to re-run Sat Setup.

    http://www.dealdatabase.com/forum/sh...hes+Dual+Tuner

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •